Fan Light Remote Control Not Working

One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct.

Fan light remote control not working.

When to buy a new ceiling fan. Replace your ceiling fan remote. Ensure that the fan s receiver and dip switches behind the remote are on the same frequency. In this case replace the reverse switch.

Below are troubleshooting steps to follow. Yes the ceiling fan remote control module may be faulty. If the remote control of your fan is not working here is what you can do to try and fix the problem. The fan will turn on and light if applicable will blink three times signaling a successful synchronization replacement remoteif the fan works without the remote via a pull chain or switch but not with the remote even though they have the same settings the remote has probably gone bad and you will just have to get a replacement remote.

Replace it with a universal model or get a replacement recommended by the fan s manufacturer. Follow the steps below to determine the cause. Now we know the buttons don t work did you try to change the battery. Confirm the reverse switch is not in a neutral position.

Remove the back of the batteries to check if you have inserted them correctly. If it will turn on the fan but not the ceiling fan lights try resetting the remote control. Replace the batteries in the remote control and turn the power back on. Turn the ceiling fan off.

Flip the switch several times to make sure it is the right. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not.

If you are using a remote or. If the ceiling fan and light works normally then the remote control module will need to be replaced. If fresh batteries and altering the settings on your fan receiver and remote did not work you may have a damaged remote control. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds.

The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. Similarly try to turn on the light by using the remote. Remove the batteries from the remote control and wait for about 10 seconds. If you cannot get the fan to turn on at all using the remote pull on the pull chain and set the fan to the highest speed.