Under sink shutoff valves also called fixture shutoffs or stop valves allow you to turn off the water to the sink or other fixture without having to use the home s main shutoff.
Faucet shut off valve replacement.
Turn on the main water supply and open the supply valves.
Identifying which type of valve you have is a good first step in replacing it.
Required tools for this project have the necessary tools for this diy project lined up before you start you ll save time and frustration.
Ask this old house plumbing and heating expert richard trethewey helps a homeowner replace the shutoff valve underneath her kitchen sink.
Prepare for valve replacement.
Shut off the water at the main shutoff valve.
Reassemble the shutoff valve turn the main house valve back on and check for leaks.
Step 2 get rid of excess water.
Then open a faucet on the lowest level of your house and another faucet on an upper level to drain the pipes.
The angle stop valve is used where the water pipe enters the room to allow for easy shut off of water flow to the end fixture allowing for maintenance and repair without having to turn water off to the entire home.
If you have a gas water heater turn the knob to the pilot position.
Subscribe to this o.
If this happens to you you can simply replace the valve with a new valve that matches the old one.
Let the water flow through the faucet to clear air in the lines and check for leaks by feeling the fittings and.
Step 1 turn off the main water valve.
Turn off the breaker to the water heater found the circuit breaker panel.
If the valve leak persists turn off the main water shutoff valve then disconnect the valve and replace it.
The sharkbite push fit end allows you to simply push on to copper cpvc or pex with no solder clamps unions or glue.
Shut down the main water valve connected to your house.
Shut off the circuit breakers to an electric water heater.
Replacing a shut off valve compression valve or angle stop may seem like a daunting task but it really takes less than 5 minutes.
These inexpensive little valves rarely get used and when they do sometimes they leak.