Fitting Carpet Runner On Stairs

Gripper and underlay should be used under stair runner carpets in the same way as they are used for any other carpet.

Fitting carpet runner on stairs.

The very last piece of the stair renovation jigsaw. Measure so that the carpet will be flush to the wall and curve completely over the tread. Click show more for links and resources stonegate carpets http bit ly 2drtd4w contact us resto. If not you may need to go down to the bottom of the first riser to get a neat join.

Pull the landing carpet down over the edge of the top step. If you want to know how to remove carpet easily from stairs check this out as companies charge uptown a few hundr. Near both ends of the tackless strip staple the runner into the crease where riser meets tread. Ease each bracket apart by taking out the dome headed screw and sliding apart using your fingers.

Runners are not installed on the stairs in one piece. If you have pie shaped or curved stairs install the carpet on the riser in the same way as mentioned above. Place the bottom part of each pair of brackets either side of the runner adjacent to the carpet edge and in the angle where the tread joins the riser. Take the stair carpet up to the top of the final riser tack it into place and trim it off in a neat line.

Beginning at the top of the stairs measure a stair tread or landing and transfer the measurement to the back of a piece of carpet with marker or chalk. 90 degree turns these are easy. For the tread start as mentioned above by fastening the carpet to the floor under the nosing and bring the carpet straight over the lip and across the tread. Even pre made runners are cut into pieces to allow proper fitting to the stairs.

When a carpet is going up the straight run of the staircase the carpet should be equidistant from the strings of the staircase on both sides so that it lies dead centre on the staircase. Tap along the runner to secure it into place by doing so you will ensure a firm hold from the carpet gripper which sits underneath the runner. Staple each edge of the runner 2 inches above bottom of riser. When you find a remnant or a piece of carpet it will essentially be cut into sections that will be installed end to end giving the appearance of a seamless runner on the stairs.

Start at the bottom of your staircase. The only main difference is that there will be a lot more excess to trim. Fit the carpet runner first. Use carpet tool and rubber mallet to pack runner tightly between the tackless strip and the riser.

If the step has a nose you can fix the landing carpet to the underside of it.