Fix Pull Chain On Ceiling Fan

Climb a ladder to access the fan and open the cover plate at the bottom of the fan where the pull chain enters.

Fix pull chain on ceiling fan.

Examine the switch to see if the chain can be reattached. Removing the fixture housing. Turn the power off at the circuit breaker for safety. Replace the old switch with a new pull chain switch then place the end cap back onto the light fixture.

Replacing a broken pull chain switch on a ceiling fan. Next remove the cover on the fan housing or the globe light so you can access the switch and unscrew the nut on the outside of the switch that holds it on. The small switch where the pull chain attaches should now be visible. Today we fix a pull chain for the fan control of a ceiling fan for free.

To fix and replace a bad on off light switch inside the ceiling fan. The plate is typically held on to the rest of the housing with three screws on the. If your ceiling fan or the light on the fan doesn t work when the chain is pulled then the problem is most likely a broken fan pull chain switch. Remove the light fixture housing from the fan.

Replacing the pull chain. Remove the old switch. Pull chain switches for light fixtures and ceiling fans can become a problem over time due to internal worn out parts a broken pull chain and in some cases the pull chain switch contacts may just wear out and stop working. Pull the switch out of the housing from the inside leaving the wires attached.

Locate the wire connections from the pull chain switch to the unit. Unscrew the screws where the light fixture attaches to the fan assembly. Pop open the switch using a small screwdriver. If needed take it.

Cut the wires to the ceiling fan pull chain switch with the wire stripper use the cutting section to snip off the two wires that attach the pull chain switch to the ceiling fan base. This is an easy fix that takes little time. Disconnect these wires and pull out the switch. The switch will also need to be replaced if the chain will not pull down or if it broke off inside the fan housing.

Next remove the end cap by turning it counterclockwise and pulling it over the chain to remove it from the fixture. This video is for en. An easy repair you. The first thing i would do in a situation like this is to consider replacing the pull chain light switch.

Leverage open the tabs along the. Leave at least two inches of wire attached to the ceiling fan base to make it easier to reattach the new pull chain switch.